岩体结构面粗糙度系数定量表征研究进展1 - 力学学报.PDF

49 2 Vol. 49 No. 2 2017 3 Chinese Journal of Theoretical and Applied Mechanics Mar.2017 1) 2) ( 014010) (110819) 1978 Barton (joint roughness coecient, JRC) . . . JRC . . (1) (2) 3D . TD325 A doi 101879-16-255 REVIEW OF RESEARCH PROGRESSES OF THE QUANTIFYING JOINT ROUGHNESS COEFFICIENT 1) Chen Shijiang2) Zhu Wancheng Wang Chuangye Zhang Fei (Institute of Mining Research Inner Mongolia University of Science and Technology Baotou 014010 Inner Mongolia China) (School of Resources and Civil Engineering Northeastern University Shenyang 110819China) Abstract The joint roughness coecient (JRC) method was suggested by International Society for Rock Mechanics to estimate joint roughness in 1978. Although this method is widely used in engineering practices, there is a shortcoming of subjectivity and experience relied on investigator. So, the research works about quantifying joint roughness were devel- oped by authors in the world. In this article, firstly, we introduced the research progress about quantitative characterization on both joint profiles and discontinuities roughnessand summarized the results of relationship between the parameters and JRC. Secondly, we evaluated the essential properties and applicability of each parameter, pointed out the problems about the parameters in obtained process including sampling interval influence, deciding triangulation of an elementary surface and determining the weight of each parameter in the comprehensive parameters method. At the same time, we gave the author’s ideas of solving the problems. In addition, we dis