自动装置考题（Automatic installation exam）.docVIP

自动装置考题（Automatic installation exam） The first chapter 1. Automatic input device for standby power supply and standby equipment: automatic input device for automatic input device for standby power supply and backup equipment, the text symbol AAT Set aside: a standby power or standby line that has obvious disconnection under normal conditions. 3 dark standby: refers to the standby power or standby equipment that is not disconnected in normal circumstances. Instead, the work is in the state of the section bus, and the segmented circuit breaker can be used for mutual reserve. Whats with the aat device: when the job power or equipment disconnected because of malfunction, can automatically rapid standby power supply or backup device will be automatically thrown into work, or the compound switch to the standby power. 5 for what are the requirements: (1) the AAT device shall ensure that the work power supply or equipment disconnected before put into standby power supply or equipment (2) the work of busbar voltage disappears, no matter any reason shall be the AAT device (3) the AAT device shall ensure that actions only once (4) the power plant factory with standby power automatic input device should be at the same time satisfy the demands of several working power supply of spare (5) the power plant factory with standby power automatic input device should meet the requirements of switching (6) should check the spare power supply and standby equipment automatic overload situation, as well as the motor since the launch of the situation, when if exceed the permitted load limit or cannot guarantee the startup device and automatic load reduction should be AAT (7) the AAT device, if the standby power supply or standby equipment and fault, and should make its speed relay protection action. 6 why does the AAT device have to be used when the working power is actually disconnecting? To prevent the input of spare power or spare equipment into fault components, the AAT installation faile