ad7705布线规则（Ad7705 wiring rules）.docVIP

ad7705布线规则（Ad7705 wiring rules） AD7705 wiring rules translation, there are a few do not understand, please point out 1.Avoid, running, DIGITAL, LINEs, the, DEVICE, because, under, they, couple, noise, onto, die., the Avoid digital wire cloth under the chip because it will noise coupled to the die? 2.The, ANALOG, ground, plane, should, allowed, to, run, be, under, the, AD7705/AD7706,, to, avoid, noise, coupling. Analog can be distributed under the chip to avoid noise coupling. 3.The, POWER, supply, LINEs, the, AD7705/AD7706, should, as, large, a, trace, as, possible, to, provide, low, impedance, paths, and, reduce, the,, effects, of, use, glitches, on, to, the, LINE., POWER, supply Widen the power line as far as possible to provide low impedance and reduce the short-time pulse on the power line. 4. FAST switching signals such as, clock signals, should be shielded with DIGITAL ground to avoid radiating noise to other sections of the board, and clock signals should never be run near the ANALOG inputs. A fast switching signal, such as a clock signal, should be wrapped to avoid radiating noise to other parts. Is shielded with DIGITAL ground a package? 4.Avoid, crossover, of, DIGITAL, and, ANALOG, signals. Avoid crossing digital and analog signals. How do digital and analog signals intersect? The digital signal is on the front of the circuit board. The analog signal is on the opposite side of the circuit board. Does this cross mean? If not, can you give me a demonstration of the 5.Traces on opposite sides of the board should run at right angles to each other.? What do you mean by not knowing it at all? This reduces the effects of feedthrough through the board. Will this reduce the feedthrough effect? 7. Using a microstrip technique works best, but it is not always possible to use this method with a double-sided board. In this technique, the component side of the board is dedicated to ground planes, and signals are placed on the solder side. Its best to use microstrip tech