水压对大直径棒材淬硬层深度的影响.PDF

Vol. 32 No. 3 安徽工业大学学报( 自然科学版) 第32 卷 第3 期 July 2015 J. of Anhui University of Technology(Natural Science) 2015 年 7 月 文章编号：1671-7872(2015)-03-0222-06 水压对大直径棒材淬硬层深度的影响 1 2 2 1 1 1 尹德福 ，陈志强 ，余延庆 ，刘 飞 ，陈其伟 ，杨树宝 (1.安徽工业大学冶金工程学院，安徽马鞍山243002；2.中冶华天工程技术有限公司轧钢事业部，南京210019) 摘要：利用MSC.MARC 有限元数值模拟软件，建立大直径棒材在线淬火有限元模型，对大直径棒材在线淬火过程进行温度场 模拟。在穿水冷却器结构确定的情况下，依据大直径棒材的淬火冷却工艺参数，进一步模拟研究水压对大直径棒材淬透深度 的影响。结果表明：模拟结果与实测结果吻合较好，当水压小于1.2 MPa 时，随着水压的增加，大直径棒材淬硬层深度增加明 显；当水压大于1.2 MPa 时，继续增大水压，淬硬层深度增加并不明显，逐渐趋于恒定值，据此大直径棒材在线淬火的水压控制 在1.2 MPa 时比较合适。 关键词：在线淬火；大直径棒材；水压；有限元模型；淬硬层深度 中图分类号：TG 156.3 文献标志码：A doi ：10.3969/j.issn. 1671-7872.2015.03.005 Influence of Hydraulic Pressure on Hardened Depth of Big Bars 1 2 2 1 1 1 YIN Defu ，，CHEN Zhiqing ，，YU Yanqing ，，LIU Fei ，，CHEN Qiwei ，，YANG Shubao (1.School of Metallurgical Engineering, Anhui University of Technology, Maanshan 243002, China; 2.Steel Rolling Division, Huatian Engineering Technology Corporation, MCC, Nanjing 210019, China) Abstract: The finite element model (FEM) of quenching process was established with MSC.MARC software, and the temperature fields of quenching process of big bars were simulated. The influence of the hydraulic pressure on hardened depth of big bars was studied based on the cooling process parameters by certain water cooler. The re- sults show that the hardened depth of simulation value and the experimental ones are identical, the hardened depth increases rapidly at first and then increases slowly even keeping constant with the increase of hydraulic pressure. 1.2 MPa may be a critical hydraulic pressure. Based on above results, the suitable hydraulic pressure of