电镀砂轮磨粒等高性影响磨削性能研究-中国测试.PDF

第42卷第8期 中国测试 Vol.42 No.8 2016年8月 CHINA MEASUREMENT TEST August，2016 doi院10.11857/j.issn.1674-5124.2016.08.028 电镀砂轮磨粒等高性影响磨削性能研究 师超钰袁 冯克明袁 朱建辉 （郑州磨料磨具磨削研究所有限公司，河南 郑州 450000） 摘 要院为解决电镀砂轮表面磨粒等高性差导致的磨削性能不佳的问题袁提出磨粒等高性的测量方法和量化指标渊Hr 和H 冤袁采用金刚石滚轮对砂轮进行微量修整袁检测磨削功率和磨削表面质量以评价砂轮磨削性能袁分析磨粒等高性与s 砂轮磨削性能的关系遥 实验结果表明院微量修整可以明显提高电镀砂轮表面磨粒的等高性袁从而改善磨削表面振纹和 粗糙度袁但应防止修整钝化曰为获得良好修整效果袁通过H 定量分析袁修整前H 值不能大于磨粒直径的30%袁修整后r r 不宜大于磨粒直径的8%遥 关键词院电镀砂轮曰磨粒等高性曰表征参数曰磨削性能 文献标志码院A 文章编号院1674-5124渊2016冤08-0135-06 Research on influences of grain height consistency on grinding performance of electroplated wheel SHI Chaoyu，FENG Keming，ZHU Jianhui （Zhengzhou Research Institute for Abrasive Grinding Co.，Ltd.，Zhengzhou 450000，China） Abstract: To solve the problem of poor grinding capability of electroplated grinding wheel caused by the difference of height consistency of grains on surface electroplated grinding wheel，the measurement methods and quantification indexes （H and H ）were proposed. Meanwhile，a preciser s dressing was carried out for the grinding wheel with a diamond roller，and the grinding performance was evaluated through monitoring the grinding power and grinding surface quality， and then，the correlation between grain height consistency and grinding performance of grinding wheel was analyzed. The results demonstrate that precise dressing can improve grain height consistency on the surface of electroplated grinding wheel distinctly，which can also improve the chatter mark and roughness of the grinding surface; however，blunt dressing sho