柯尼卡复印机代码（Konica copier code）.docVIP

柯尼卡复印机代码（Konica copier code） Konica copier code 1. development bias adjustment. (1) adjust the multimeter to: 1000VDC (remember to burn non - destructive multimeter) (2) the COM table (pen with black pen) is connected with the main control board of the CN12-1 + 2 (the red pen) to ground (GROND). (3) entering the 47 mode (4) enter numeric keys 1 and 2. (5) press copy key. (6) then adjust the master board VR1 so that the output is -180V. (7) press stop / remove key. (8) turn off the main switch to relieve the 47 mode. 2. check toner concentration in the developer. (1) entering the 47 mode. (2) enter numeric keys 5 and 0. (3) press copy key. The copy counter flashes for 90 seconds, and the data will be displayed on the copy counter. Then, according to the following formula, find out the actual percentage of the toner in the following data. Formula: toner concentration data, =25-[, data on copy counter +13=6%; +6=5%; 0=4%; -6=3%; -13=2% (4) press stop / remove key. (5) turn off the main switch to relieve the 47 way. 3. toner concentration adjustment (usually for replacement of new developer). (1) replace the new developer. (2) entering the 47 mode. (3) enter numeric keys 5 and 1. (4) press the copy key, and the M1 (main motor) rotates for about 3 minutes. (5) turn off the main switch to relieve the 47 mode. 4. band adjustment. (1) distribution plate polished all open, enter the 47 way. (2) enter numeric keys 9 and 6. (3) press the copy key (the exposure lamp is moved to the middle of the glass plate). (4) press the copy button again (the exposure light lasts 3 seconds). (5) put a sheet of white paper on the glass board. (6) the width of the ends of the band must be equal; the band must be above the seam; adjust the left and right mounting points of the exposure light, So as to make the shining part narrow. (7) turn off the main switch to relieve the 47 mode. Please follow the following criteria: Adjust the light contact plate to make the vacuum point of the lamp (the pr