考虑有支撑暴露影响的基坑变形设计方法的修正（Modification of deformation design method for foundation pit considering the influence of support exposure）.docVIP

考虑有支撑暴露影响的基坑变形设计方法的修正（Modification of deformation design method for foundation pit considering the influence of support exposure） Modification of deformation design method for foundation pit considering the influence of support exposure The deformation control method of foundation pit following the space-time effect theory takes into account the deformation law of foundation pit in exposed stage without support. However, the displacement change of retaining walls and the influence of different strengthening conditions on the retaining wall exposed to deformation under the condition of support exposure are not considered. According to the measured deformation rate data and reference structure characteristics of Kelvin model, considering the FS resistance coefficient of passive zone KH correction factor supporting the exposure time and soil reinforcement under the conditions of (TS) FS expression was determined by inverse analysis method (TS) in the parameter value. 1 、 design principle of deformation control of foundation pit The general calculation principle of retaining structure is based on the finite element method. Figure 1 shows that the retaining structure above the excavation face adopts the beam element, and the bottom of the foundation is the elastic foundation beam element, and the support is the elastic supporting element. The load is the earth pressure and water pressure on the driving side. For the beam element, the beam axis is x axis, and the stiffness matrix expression of the beam element can be written out. Type: Xi, XJ - node, I, J axial force; Yi, YJ - node i and j shear force; Mi, MJ - nodal I and j axial displacement; Phi I, Phi J - node i and J corner; Modulus of elasticity of e retaining structure; Moment of inertia of section of retaining structure of i; A retaining structure section area; L - unit length; The stiffness matrix of the support element is: Formula: e - support or anchor material elastic modulus; A - support sectional area; L - s