放坡系数及计算（Slope coefficient and calculation）.docVIP

下载本文档

76
0
约4.88千字
约 5页
2017-07-23 发布于河南
举报
版权申诉

放坡系数及计算（Slope coefficient and calculation）.doc

1、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。。
2、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。
4、该文档为VIP文档，如果想要下载，成为VIP会员后，下载免费。
5、成为VIP后，下载本文档将扣除1次下载权益。下载后，不支持退款、换文档。如有疑问请联系我们。
6、成为VIP后，您将拥有八大权益，权益包括：VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
7、VIP文档为合作方或网友上传，每下载1次，网站将根据用户上传文档的质量评分、类型等，对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档

放坡系数及计算（Slope coefficient and calculation）

放坡系数及计算（Slope coefficient and calculation） H is high, S and S are upper and lower surface areas, respectively. Soil slope coefficient, soil slope coefficient (m): (as shown) refers to the soil wall slope bottom width of B and high ratio of m=b/h, or tan =K 1, alpha calculation in the construction, the slope should be started from the upper surface of the cushion; 2, pipeline earthwork calculation of earthwork trench digging quota, the slope coefficient is defined as follows: (1) digging depth within LM, without considering the slope; (2) the depth of excavation in 1.0lm ~ 2.00m, according to the l:0.5 slope; (3) the depth of excavation in 2.0lm ~ 4.00m, according to the l:0.7 slope; (4) the depth of excavation in 4.01m ~ 5.00m, according to 1:1 (5) excavation slope; the depth is more than 5m, according to the calculation of slope stability of soil slope by theory. Note: when calculating the amount of work, the repeated output of the slope at the junction of the geosyncline will not be deducted. Because the soil is not good, when the foundation is treated by digging and changing the soil, the slope should be started from the actual digging. In the excavation of earth, trough and pit, in case of different soil types, they shall be calculated separately according to geological survey data. The slope of the slope coefficient according to the soil type and depth weighted set the table data in every place is not applicable, only general rules, according to the new standard 2009 handout: soil type single soil, soil (one or two) excavation depth more than 1.2 meters to the slope (K=0.50), soil (Kennedy three or four) the excavation depth more than 1.7 meters to the slope (K=0.30). Soil mixed soil, excavation depth more than 1.5 meters to the slope, and then according to the different soil on slope coefficient weighted construction manual K. construction in the provisions of the slope coefficient of slope height, slope ratio to determine soil depth specified categories (m) h