放样全部步骤（Lofting all steps）.docVIP

放样全部步骤（Lofting all steps） Detailed process steps of setting out coordinate of total station instrument Best answer 14. lofting survey Lofting measurements are used to locate desired points on the field. In the process of setting out, by comparing the angle, distance or coordinate measurement on time, the instrument will show the difference between the lofting value and the measured value in advance, so as to guide the lofting. Display value = measured value lofting value Lofting measurements shall be carried out using the left position of the panel. 14.1 distance lofting survey The required point is set according to the horizontal angle that is rotated from a reference direction and the distance from the measuring site. Operation process operation key display 1. as shown on the right a reference direction. 2. press the button at the [zero] when the button is set on the second page menu of the measurement mode. Set the reference direction to zero. [nulling] [measurement] H ZA 99 degrees 43 13 HAR 0 degrees 00 00 P2 Setting zero coordinate setting out record Operation process operation key display 3., in the measurement mode second page menu press [lofting], into the lofting measurement mode. In menu mode, select 2. lofting survey to complete the same function. ? [lofting] [lofting survey] 1. lofting data 2. lofting observation 3. station setting 4. azimuth 4. select 1. lofting data, press [] to enter the lofting data input screen. Enter the lofting distance and the angle of setting out. After each item of data is lost, press []. [] [lofting distance angle] Hm: HA: Coordinate determination 5. press [determine] enter the setting out observation screen. Among them: DH: the horizontal distance difference between the target and the point to be set. Difference of horizontal angle between dHA: target and point to be set. [determination] [distance lofting] DH DHA -119 degrees 23 18 HAR 0 degrees 00 00 Corrective Mode Guided Measurement 6. [] according to the guide into the l