plc的尾部接线（PLC tail connection）.docVIP

plc的尾部接线（PLC tail connection） PLC uses a ladder diagram language that is very similar to the relay circuit diagram. If the relay control system is modified by PLC, it is a shortcut to design ladder diagram according to the relay circuit diagram. This is because the original relay control system through the use and test of long time, has been shown to complete the functional requirements of the control system, and relay circuit diagram and ladder diagram have many similarities, so it can be translated into a circuit diagram of relay ladder diagram, with external hardware wiring diagram and ladder diagram of PLC there are a lot of similarities to the function of the system, relay. This design method generally does not need to change the control panel, maintaining the original external characteristics of the system, operators do not change the long-term formation of operating habits. 1, basic methods The relay circuit diagram is a purely hardware circuit diagram. When it is changed to PLC control, it is necessary to use PLC external wiring diagram and ladder diagram to equivalent relay circuit diagram. Imagine that PLC is a control box, the external wiring diagram describes the control box of the external wiring, the ladder is inside the road map of the control box, the ladder in the input and output is the control box and the outside world interface relay, so you can use the the analysis method of relay circuit diagram to analyze the PLC control system. When analyzing the ladder diagram, the contact of the input bit can be imagined as the contact of the corresponding external input device, and the coil of the output bit is assumed to be a coil corresponding to the external load. In addition to the control of the ladder diagram, the coil of the external load can be controlled by the external contacts on the right. The steps of converting the relay circuit diagram into an external wiring diagram and a ladder diagram of the same function PLC are as follows: 1) understand