proe工程图（Proe engineering drawing）.docVIP

proe工程图（Proe engineering drawing） engineering drawing 1. using CNS engineering drawing standards File - file properties - drawing options - Open - dot CNS-CHINA.dtl Note: this setting is only valid for current engineering drawings and does not apply to engineering drawings that will be opened later Tools -- options -- drawing_setup_file -- browse -- specify CNS-CHINA.dtl Note: this setting file is only valid for subsequent works drawings, not applicable to previous engineering drawings 2. parts detail Insert - drawing view - Detail - specify the extent of the local detail - select the view, place the view- - produce partial detail 3. auxiliary view Insert - drawing view - assist - select (bevel) - select the placement of views - generate Auxiliary view 4. rotated section Insert - drawing view - rotate - select the parent view of the rotated section (determine which view of the rotation section is cut.) Select the location of the rotated section select an axis as the axis of rotation (or select a plane, then the PROE system will seek the intersection of the plane and the plane in which the view is present Axis of rotation that produces a rotational profile. 5. interrupt view Drawing view - visible area - breaking view - point + - selects even numbers to define a cut Breaking area -- breaking pattern, setting up the line form of cut line 6. part view Draw a part of a view, and omit or break the view of other parts of the view Select the drawing view -- the partial view -- select a point as the central point of the partial view -- the left mouse button Point out a closed curve - generating a partial view Note: a partial view is a partial view of the view, and the partial detail is to enlarge the view View of 7. specific faces Make the view show only the view of the particular surface or plane selected by the user Insert - drawing view - select a bevel to project an auxiliary view vertically from the side view of the selected view Position - drawing view - Section optio