写真机问题集锦（Photo album）.docVIP

写真机问题集锦（Photo album） A box of broken ink figure appeared when the grating stolen goods, with a cotton swab dipped under water to scrub the grating, should rub several times after washing with a dry cotton swab wipe water. (Guangzhou Tianyi technology ) Tel: 020QQ:426010368 Two: can not recognize the ink box: decryption needs to be inserted again, or decryption card is broken. Three: Map: 1. Belt pulley dislocation rub card, need to adjust the belt pulley. The servo motor is broken, need to replace the servo motor. 3 the copper ring is dirty, need to clean or replace the copper ring. Four: spray ink: 1 car plate fever, need to shut down the machine rest. The electric shock led astray, need to be replaced with electric shock. 3 the nozzle wall, for pumping washing nozzle. The ink pipe interface is blocked, several times more need to unplug the plug nozzle, nozzle position and interference, swap with a paper towel, the pad in the nozzle and shock belt to check the sprinkler nozzle replacing interference. As the four nozzle without ink, in the exclusion of interference is not after the ink nozzle is the car plate broken. Five: no paper: 1 paper is dirty, with cotton swab dipped water scrubbing. The paper is not installed, reinstall the need. 3 test paper is bad, need to change the test paper. The car plate is broken, need to be replaced. Six: a map edge inclining to one side: 1. The servo motor is broken, need to replace the servo motor. The grating sensor is dirty, use cotton swab dipped water scrubbing. The grating sensor is out of order and needs to be replaced. Seven: boot small frame frame: 1 grating sensors hit the left dirty, need to be cleaned. The grating sensor is broken, need to be replaced. C. The data cable is not plugged in, need to insert a few times. Eight: frequent paper: 1 feed sensor is dirty, needs cleaning. The feed sensor not plugged in or connected with the main board contact is not good. 3 feed sensor is bad, need to change. Nine: when