analysis and design of reinforced concrete …（分析和设计的钢筋混凝土u2026）.pdf

1126  Analysis and Design of Reinforced Concrete Deep Beams by a Manual Approach of Stringer-Panel Method Abstract André Felipe Aparecido de Mello a D-regions are defined by its non-linear strain distribution over a Rafael Alves de Souza b cross section. Deep beams are an example of D-regions, as most of its load is usually directly delivered to supports by arch mecha- a Civil Engineer, nism. The present paper focus on the Stringer-Panel Method Postgraduate Program, State (SPM), an alternative procedure to some well-known methods for University of Maringa designing this type of structure, i.e., strut-and-tie method and finite element method. A manual approach of SPM is presented, b Full Professor of Civil Engineering by means of a simple principle of dividing a structure on two Department, State distinct elements: stringers, which absorb normal forces, and pan- University of Maringa els, which absorb shear forces by membrane action. Two practical examples of deep beams designed using SPM are presented and Corresponding author: their overall behavior were investigated by means of non-linear a andrefm.eng@ analysis. Obtained results have shown that SPM is a very attrac- b rsouza@uem.br tive alternative for analyzing reinforced concrete deep beams. /10.1590/1679 Keywords Stringer-Panel Method; D-regions; deep beams; non-linear analy- Received 16.11.2015 sis. In revised form 12.02.2016