asn#230;s power station nicholas kristensen, bwe …（asn # 230;s电站尼古拉斯u2022kristensen防波堤入口u2026）.pdf

The flexible design of the CT-121 FGD – a perfect match for DONG Energy’s Asnæs Power Station Nicholas Kristensen, BWE A/S (Denmark); Sohsuke Kido, Chiyoda Corporation (Japan) 1 Introduction The two older coal fired boilers #2 and #4 at the Asnaes Power station are not equipped with flue gas desulphurization equipment. Therefore, as the latest emission requirements of the EU Large Combustion Plant Directive cannot be met, the two units can no longer be operated. The plant owner DONG Energy has decided to install a new FGD plant to treat the flue gas from the 147 MWe Unit 2 while Unit 4 has been mothballed. One design criteria for the new Unit 2 FGD has been that, with only minor modifications, the system must be able to treat the effluents from a possible future upgrade of the 400 MWe Unit 4. Focus by the client has been on a simple though reliable low cost solution and a short project execution time of 23 months. Among other things this scrubber will be the first outdoor FGD plant for a Danish utility boiler and also the first Danish FGD with a wet stack. To overcome the pressure drop of the FGD system, a new booster fan will be installed in the A position, upstream the FGD (outside the scope of the FGD supply). There will be no by- pass system and the treated flue gas will be led directly from the FGD to the wet stack (also outside the FGD scope) without reheating . At the absorber outlet, there will be an empty casing for a possible future flue gas reheater to be installed. The Jet Bubbling Reactor (JBR) itself plus mist eliminator and reheater casing will be made of flaked glass-lined carbon steel, the flue gas cooling inlet section will be made of solid Hastelloy C276, and the clean gas duct will be made of FRP. 2 The CT-121 jet bubbling process The heart of the process is the Jet Bubbling Reactor (JBR). As oppos