固态继电器的检测方法和接线图（Detection method and wiring diagram of solid state relay）.docVIP

固态继电器的检测方法和接线图（Detection method and wiring diagram of solid state relay） Detection method and wiring diagram of solid state relay Have been viewed: 128 release time: 2013-01-17 1. identify input and output pins and measure both good and bad On the shell of AC solid state relay, the input is usually labeled +, - and INPUT, while the output is positive and negative, but some devices are labeled LOAD. As for DC solid state relays, they are labeled + and - at the input and output points, and some devices are marked with IN (input) and OUT (output) to indicate the difference. Discriminant input, input with digital multimeter, can use diode stalls, respectively positive and negative test on the four pin, there must be a measure of pin voltage between the values of positive conduction, reverse cut-off rule, namely measuring display 1.3 1.6V, 1 symbol display overflow reverse test. It can be concluded that the two pins as input, and in measuring, display a measurement of 1.3 ~ 1.6V , the red pen is positive, the black pen connected to anode. For a DC solid state relay, the positive and negative poles of the output are generally opposite to the horizontal 22 when the input is found. It is necessary to point out that some of the output DC solid state relay terminal with a protective diode, cathode protection tube electrode solid-state diode, the anode protection tube is connected with the cathode of solid state relay test, should pay attention to distinguish. Test example: The device to be tested is a JGTIFA type DC solid state relay. Its shape and internal structure are shown in figure 5-78. Its output end is connected with protective diode. For the convenience of narration, the four pins of the device are marked, i.. When testing, the two pins of the input are distinguished first. Using the DT890A type digital meter diode file, the positive and reverse measurements are carried out on one, two, three and four. The test data shows that when the probe connected to the foot, th