修车小技巧3（Tips on repairing cars 3）.docVIP

修车小技巧3（Tips on repairing cars 3） Tips for repairing cars Minor surgery for serious illness A TOYOTA Lorna 4 cylinder 1.8L EFI car, equipped with automatic transmission. When the car is idling into the D or R block, the engine shock, idling unstable, or even flameout. Diagnosis of automatic transmission failure. The car model is older, accessories are not easy to buy, the owner is not willing to spend thousands of dollars for the cost of this car, and the exclusion of the car fault is also a laborious time-consuming work. However, after a fault diagnosis, a small operation solved the big problem of the car. Consider the cause of the car failure, idling engine flameout because the engine load increased after hanging, because the owner does not require high, as long as the gear is not stopped on the line. If you start from the idle control to solve, in the gear up to increase the engine speed, then the engine torque increases, it will not because the load is too large and flameout. The idle speed control system of the car is simple, and the idle by-pass air passage has no electronic control mechanism. Only one screw is used to control the idle speed of the engine in steady state. The engine speed is adjusted by this adjusting screw, and even if it is turned to the limit position, the phenomenon of stop and flameout is not obviously improved. It looks like an operation must be done. Surgery is very simple, as long as the bypass airway in parallel with a solenoid valve control of the airway can be. The action of the solenoid valve is determined by the signal of D and R in the gear. After the electromagnetic valve receives the hang signal, the air inlet is opened, the air intake of the engine is increased, and the rotating speed is correspondingly increased, and the engine will not stop because the load is too large. Comment: this method is simple and effective. Solenoid valve can be used to increase the speed of ordinary Santana air solenoid valve replacement. The contro