会计实务笔记11-第十一章 所得税会计（Accounting practice notes 11- chapter eleventh income tax accounting）.docVIP

会计实务笔记11-第十一章 所得税会计（Accounting practice notes 11- chapter eleventh income tax accounting） To be the peak of successive convex surface, the machining accuracy can reach 0?.1 to 0 m.01 m?. 3) the shape precision is high, when grinding, the workpiece is in the free state, the force is even, the movement is steady, and the movement precision does not affect the shape precision. The cylindricity of the processed cylinder can reach 0.1 M. 4) to improve the surface mechanical properties of the workpiece, the abrasive cutting heat is small, the workpiece deformation is small, the deterioration layer is thin, the surface will not appear micro cracks. At the same time, it can reduce the surface friction coefficient and improve the wear resistance and corrosion resistance. There is residual compressive stress on the surface of the grinding parts. This kind of stress is beneficial to improve the fatigue strength of the workpiece surface. 5) research doesnt require grinding by lapping tool and equipment in general is relatively simple, does not require high accuracy; but the research materials in general than the soft grinding workpiece, are subject to wear, should pay attention to timely repair and replacement. 3. classification of grinding (1) according to the automation degree of grinding process 1) manual grinding of the relative movement of the workpiece and the tool is manually operated. The quality of the process depends on the skill level of the operator, labor intensity and efficiency. Applicable to all kinds of metal, non-metallic workpiece surface. Die parts of the local narrow, deep hole, blind hole slot, and the dead, are still using manual grinding. 2) one of the semi mechanical grinding parts and tools is simple mechanical movement and the other is manual operation. Processing quality is still related to operator skills, and labor intensity decreases. It is mainly used for grinding internal, external, cylindrical, plane and conical surfaces of workpieces. Die part