压力注胶方法（Pressure injection method）.doc

压力注胶方法（Pressure injection method） Abstract: adhesive bonded steel sheets have been widely used in bridge maintenance and reinforcement, and better reinforcement results have been achieved. The only bridge reinforcement maintenance * * actual operation and test in project management, the quality control points of pressure grouting paste steel plate construction is expounded, analysis of the causes of quality defects of the treatment method and put forward. Key words: sticking steel plate; bridge reinforcement; quality control * * bridge length 2898.02m, opened five years later because of the design of the bridge girder bearing capacity and safety stock is small, the need for main beam (20m, 30m and 50m span hollow slab span box girder) bottom pressure grouting paste steel reinforcement, a total of 1787 pieces of reinforcement girder, using pressure grouting paste plate of 24021.4 square meters, a single bridge bonded steel plate reinforcement scale for the first in the country. As the site leader of the project, I participated in the whole process management of the project. Here, I talk about the quality control points, the quality defects and the treatment methods of the pressure grouting method, the bonding steel plate reinforcement, the bridge construction, and some of my experience. Material quality control The key approach reinforcement materials used should be conducted after the sampling, identification unit letter sent to the site as a qualified testing, the indicators have reached the national and industry relevant technical rules and regulations and the requirements of design documents before use. Structural adhesive and edge banding adhesive: structural adhesive used for bridge reinforcement shall be of grade a glue. The structure and properties of rubber sealing should comply with the code for design of reinforced concrete structure (GB50367 - 2006) corresponding regulations, at the same time, such as the design of some performance indexes have special re