在写刀路之前,将立体图画好后,要将图形中心移到坐标原点,最高点移到Z=0,方可以加工,铜公火花位可加工（Before writing the knife path, after the stereo picture is good, the center of the picture is shifted to the coordinate origin, the highest point is moved.doc

在写刀路之前,将立体图画好后,要将图形中心移到坐标原点,最高点移到Z=0,方可以加工,铜公火花位可加工（Before writing the knife path, after the stereo picture is good, the center of the picture is shifted to the coordinate origin, the highest point is moved Before writing the knife path, after the stereo drawing is finished, the center of the picture is shifted to the coordinate origin, and the highest point is moved to Z=0, so that the copper can be processed, and the copper spark position can be processed with negative reserve. Before processing, it is necessary to check whether the clamping direction of the workpiece is the same as that in the computer, whether the position is correct in the mold, whether the fixture is blocked, and whether the direction of the front die and the die match. Also check whether the tools you use are complete, the standard in the meter, and so on. Matters needing attention in processing copper: Determine the spark position, the general juvenile Gong (ie, Jing Gong) reserve amount of 0.05~0.15, rough male 0.2~0.5, specific spark size can be made by master die. Copper public no processing of the dead corner, whether it is necessary to dismantle one more scattered public?. Toolpath of br/ processing of copper industry in general is: large (flat row knife) rough - knife (knife) angle #0; light use knife knife surface. Rough teachers with a flat knife is not a knife, knife with a knife after rough, then the shape of light to the number, then use knife light surface large, and small knife light surface dont plan, for some small angle and with a knife to the dead can not processing sword knife cutting range limit in order to avoid air knife, live too much. Copper Gong, especially the young male, is of higher precision, and the tolerance is usually 0.005~0.02, and the distance is 0.05~0.3. When you open the crude copper knife a knife Liu Qiu, which will shape copper rough deep a knife radius. The br/ copper is also to be processed in the middle, the table calibration, the spark discharge to