基坑1（Foundation Pit 1）.docVIP

基坑1（Foundation Pit 1） (1) the foundation pit surrounding rainwater, take the formation of gullies in the pit bottom brick side, in the mining water ditch ends set, the specific size is as follows: the gullies were obtrapezoid, mouth width 500mm, mouth width 300mm, below the bottom 0.5m. The set of wells with diameter of 0.8m and below the bottom elevation of 1m, after pouring position of drainage sump to quasi built effectively within the drainage pit in the. Water pump is placed in all the water wells, and after the rainwater is collected, the hose is connected with the hose of the submersible pump to flow into the municipal pipe inside the field. 2, well drain well distributed detailed drawings: 3, the choice of groundwater drainage equipment, foundation pit groundwater drainage widely used power pumps, generally motorized, electric, vacuum and siphon pump. When the pump type is used, the displacement of the pump is 1.5 - 2 times as much as that of the foundation pit. When the water quantity of the foundation pit is Q20m3 / h, the diaphragm pump or submersible pump can be used; when the Q is in the 20-60m3 / h, the diaphragm or centrifugal pump or submersible pump can be used; when the Q60 m3 / h, the multipurpose centrifugal pump is used. Diaphragm pump displacement is small, but it can exclude mud water, the choice should be based on the technical performance of water pump selection. According to the size of the actual water, the number and type of precipitation machinery are determined. Fifth sections of earthwork excavation procedures (1) the general order and method of earthwork excavation; The mechanical engineering earthwork delamination excavation, the layer thickness of 20 mm or so, and the foundation pit excavation and retaining mechanical cross synchronously, dig to design elevation of 300mm at the bottom of the pit stop into the artificial excavation, picking up the bottom edge. (two) the method of mechanical excavation 1 、 main machines and tools: (1)