开关机加速（Switching machine acceleration）.docVIP

开关机加速（Switching machine acceleration） Boot: First, open the system properties (on my computer right - properties, or in the control panel to open the system, the shortcut win+pause break) the Advanced tab, in the startup and recovery , open the Settings , two Chinese removed the boot zone. If multiple users of the system to retain the display list of operating system time tick. Click Edit to make sure that the additional attribute for the startup item is /fastdetect instead of nodetect. Do not add the /noguiboot attribute first, because you will also need to use the guiboot later. The next step is the key in the system properties to open hardware tab, open the device manager, IDE ATA/ ATAPI controller , double-click to open the secondary IDE channel property, advanced settings tab, the equipment 1 and 2 transfer mode to DMA if available if you can choose, equipment type no is selected as the no, point to determine the complete set, the main IDE channel set the same method. Open the registry (start - run -regedit), click my computer, open the edit menu, find, enter AutoEndTasks, and find the next one. Double click open to find the result and change the value data to 1. Then you can find the HungAppTimeout, under AutoEndTasks WaitToKillAppTimeout, the value data to 2000 or less, but also to modify the menu delay time by the way here, find MenuShowDelay in the AutoEndTasks below, the value is in milliseconds, if you want to remove the menu delay to 0. Modify the edit menu, open the find next (shortcut key, F3), and install the steps you have found in a step by step method. Now the startup and shutdown of the acceleration have been completed, restart the computer, feel the feeling of speed start, scroll bar is not only transferred one or two laps on the OK. Enjoy the fun of speed after the restart and then we look to further accelerate the speed of startup, open the system properties - advanced - startup and recovery settings, open the boot area of editing, plus /noguib