开挖机（Excavator）.docVIP

开挖机（Excavator） How do I drive the excavator? Read [677] [2008-12-10] -------------------------------------------------------------------------------- I. excavators drivers shall comply with the general safety technical regulations. Two, excavator before work, should do the following preparatory work: 1, understand the construction conditions and tasks to the construction staff. The contents include the height and depth of excavation, the height of slopes and wires, underground cables, pipelines, tunnels, graves and various obstructions. After the excavator enters the site, the driver shall comply with the relevant safety regulations at the construction site. 2 when excavators work in stony soil or frozen ground, blasting should be carried out before excavation. 3, according to routine maintenance project, excavator inspection, maintenance, adjustment, fastening. 4, check fuel, lubricating oil, cooling water is sufficient, should be added when not enough. Do not smoke or approach open flame when adding fuel, so as not to cause fire. 5. Check whether the insulation and switch contacts are good. 6 、 check the hydraulic system of each pipe and operation valve, work cylinder, oil pump, etc. whether there is leakage, the action is unusual. 7. Check whether the clips of the wire rope and the fixed wire rope are firm and reliable. 8, the main clutch lever in the neutral position, starting the engine (if the hand starting to pay attention to handle counter wounding; if the rope can not start, the rope around your hands). Check the instrument, transmission mechanism, working device, brake mechanism is normal, after confirmation of the correct, you can start work. 9, after the engine is started, no one is standing on the bucket, arm, track and machine shed Three, excavators in the work should pay attention to the following safety matters: 1, excavator work should be parked in a solid, flat ground. Tire excavator should take good leg. 2, the excavator work should be in a horizo