脚手架通病控制（Scaffolding fault control）.docVIP

脚手架通病控制（Scaffolding fault control） Problems existing in erection of fastener steel pipe scaffold and Countermeasures Scaffolding is the main construction tool in construction. For example, masonry, masonry formwork, pouring concrete, decorative paint, structural components installation, etc., need to set up scaffolding, in order to operate. If the scaffolding erection is not as good as the current situation, it is necessary to delay the time limit; if the scaffold is not built firmly, it will easily cause casualties in construction. Therefore, the selection of scaffolding, structure, erection quality must be taken seriously. Aiming at the construction site scaffolding design and construction, the problems in the use and unsafe factors, in order to ensure the safety of the scaffold is reliable, economical and reasonable, to prevent the occurrence of accidents, the state promulgated the industry standard steel tubular scaffolding construction safety technical specifications (JCJ1302001) on June 1, 2001. This standard is divided into 9 chapters and 183 sections. 24 of them are mandatory provisions. The main contents are: the requirements of construction and inspection and acceptance to the construction safety management and the design of load calculation parts the general terms of the symbol. So far, the standard has been introduced for 3 years, but in the inspection found that many sites in the implementation of many irregularities. Quality standard for scaffold steel pipe and fastener 1. steel pipe: standard stipulates: scaffolding steel pipe should be used in the current national standard straight welded pipe (GB/T3092) in the provisions of 3 ordinary steel pipe. Its quality should be in line with the current national standard carbon structural steel (GB/T700) Q235 - class a steel requirements. The largest single steel scaffolding quality should not be more than 25kg, should adopt Phi 48 * 3.5 steel. Steel pipe surface should be flat and smooth, there should be no c