蓝牙卡故障（Bluetooth card fault）.docVIP

蓝牙卡故障（Bluetooth card fault） Remote Bluetooth card reader and Bluetooth card fault removal remote Bluetooth card reader: 1, read card does not respond, do not read card, read card light is not bright, not flashing, buzzer does not ring 1) check the power supply; whether the power is connected or not. If you are not using the power supplied by the manufacturer, check the power parameter matching problem (12V/3.2A). The switching power supply has unstable output and presents virtual pressure. At this point, it is necessary to use multimeter to measure the voltage of input card reader, whether or not there is a power supply with multiple loads, and it is recommended that the reader supply power individually by 12V. 2) check whether the card can work normally; confirm the card read card reader, card reader protocol, multiple protocols. The card is tested with Bluetooth, which can avoid the damage caused by test card cannot read card phenomenon, or a site has more than one card reader under the condition of using the test card to another card reader test, to confirm whether the normal work of the test card. Look for other reasons. 3) check whether or not to lower the sense of reading card; card reader has set up a virtual depression settings, check the setting code (U27 number one, whether the code in the ON file). 4) check whether the card reader infrared code is closed or not. The card reader and card work mode is the infrared protocol to wake up the card. Do not read the card when checking (U11+U12 total 8 yards), the code is in the ON?. If all is OFF and the infrared is off, the card reader cannot activate the wake-up card, resulting in a failure to read the card. Check whether the infrared has no work, you can use the camera of the mobile phone to check the infrared emitting tube (white LED as the infrared emitting tube), whether or not to shine. 2, can read card, reading card light also flash, but no card number? Check that the line is properly installed. If you are