检测修复磁盘（Detection recovery disk）.docVIP

检测修复磁盘（Detection recovery disk） I. using grammar 1. Test and repair the disk file system: SCANDISK drive: 1 / ALL / CHECKONLY / 1 of AUTOFIX / NOSAVE / SURFACE: 2. Check and fix a self - fail volume file compressed by DriveSpace: SCANDISK drive: \ DRVSPACE. NNN / CHECKONLY / AUTOFIX / NOSAVE /. 3. Detects a single damaged file: SCANDISK / FRAGMENT [drive:] [path] filename 4. Scanning only detects errors that are not repaired: SCANDISK / UNDO [drive:] Two, the use of parameter description? [drive: Specifies the disk drive required for testing or scanning; / ALL Check and repair all current drives; / AUTOFIX Does not prompt for automatic repair of damaged file systems; The CHECKONLY detects the drive, but does not fix any damaged file system; / CUSTOM According to scandisk. Ini settings to customize and run the ScanDisk disk scanner The NOSAVE and / or AUTOFIX use to delete the missing file cluster content instead of saving the cluster content as a file; NOSUMMARY and / or CHECKONLY / AUTOFIX use, ScanDisk is not interrupted while displaying full screen detection summary information; SURFACE performs disk surface scan after other tests; MONO using ScanDisk on a monochrome display; Detects and fixes the current drive file system, directly type SCANDISK without any arguments. Three, use scandisk. INI file to customize the operation of ScanDisk Scandisk. The INI file contains custom parameters for the ScanDisk program, using these settings only in single user mode MS DOS prompt, and in Win 95 unless the compressed volume file used to check a bootstrap, or run ScanDisk cannot use these settings. 1. Environment used: the [ENVIRONMENT] region contains the following settings to indicate the characteristics of ScanDisk. The following part of = indicates the default default parameter value of the system, and the value after , is an optional value. [ENVIRONMENT] is set as follows: Display = Auto; Auto, Mono, Color, Off Mouse = On; On, Off ScanTimeOut = On; On, Off NumPasses = 1