混凝土塌落度（Concrete slump）.docVIP

混凝土塌落度（Concrete slump） The slump is mainly refers to the plasticizing properties of concrete and pump performance, influence of concrete slump mainly include change of grading, water content, cross the weighing error, dosage of admixture can be neglected and the temperature of cement. Slump refers to the workability of concrete, in particular, to ensure the normal operation of the construction, including the water retention, fluidity and cohesiveness of concrete. Workability is defined as whether concrete is easy to construct, operate uniformly and closely. It is a very comprehensive property including fluidity, cohesiveness and water retention. Influence and workability are mainly affected by water content, water cement ratio, sand content and cement content, aggregate condition, time and temperature, admixture and so on. Test method: the bucket slump slump a catchy 100mm, 200mm, high 300mm horn, pouring concrete after tamping, and then pull up the barrel, concrete slump phenomenon due to weight, with a barrel high (300mm) minus the collapse of concrete after the highest point of the height, called the slump. If the difference is 10mm, while the slump is 10. Concrete slump should be decided according to the building structural section, the content of the steel bar, casting method, transport distance, transport mode, vibration capacity and climate conditions, the selected proportion should be considered, and should adopt the smaller slump. Edit this section on the production and construction aspects of concrete slump Concrete raw material influence Shahe as the storage time and washed sand of different batches, unstable water content, and through the test to determine the moisture limitation, coarse aggregate general water content is relatively stable, but sometimes change, reason is the most open storage aggregate plant, changes in the aggregate after the rain water content, mixing of concrete the water absorption rate of different aggregate concrete slump will cau