混凝土试块送检（Concrete block inspection）.doc

混凝土试块送检（Concrete block inspection） I. General Provisions 1 strength grade of concrete should be divided according to the standard value of compressive strength. The strength grade of concrete by the symbol C and cube compressive strength standard value (N/m square meter). 2 cubic compressive strength standard value refers to the length of production and maintenance according to the standard methods for 150mm specimens, in the 28d age, standard test method for measuring a value distribution of the compressive strength, strength is lower than the percentage of the value of not more than 5%. 3 the strength of concrete shall be examined and evaluated in batches. A batch of concrete shall be made of concrete of the same strength grade, the same age, and the same process conditions and the same mixing ratio. The cast in place concrete of the construction site shall be divided into acceptance batches according to the acceptance items of the unit works, and each acceptance item shall be determined in accordance with the current national standards quality inspection and evaluation standards for building installation works. 4 the precast concrete plant, precast concrete component plant and the construction units using on-site concrete mixing shall be evaluated in accordance with the statistical method specified in this standard. A small batch of concrete or field stirred concrete for sporadic prefabricated components may be assessed in accordance with non statistical methods specified in this standard. 5, in order to meet the requirements of concrete strength grade and concrete strength evaluation, the concrete mixing strength should be chosen according to concrete conditions such as raw material, concrete production process and production quality level. The strength of concrete construction may be determined in accordance with the provisions of appendix two of this standard, in accordance with the specific circumstances of the unit. 6 the concrete mixing plant, precast concr