发动机拆装（Engine disassembly）.docVIP

发动机拆装（Engine disassembly） Engine disassembly maintenance data database general buick - skylark, ozmobier-archivo, and bytik-big Am engine mechanical systems Engine disassembly 1. Disassembly of engine assembly Warning: the instant engine is out of fire and the fuel system still has oil pressure. 1.2.3 L and 2.4 L engines The engine and the transmission bridge are disassembled. 1) unplug the oil pressure of the fuel system and break the negative electrode of the battery. 2) the cooling system should be released and the coolant should be recovered if it is equipped with air conditioning (A/C). 3) remove the left sound insulation board and remove the clutch putter from the pedal (only the variable speed drive axle). 4) remove the heater hose and remove the radiator hose from the thermostat shell, remove the air filter from the air filter to the throttle body air pipe, remove the radiator mounting bracket and cooling fan assembly. 5) if air conditioning (A/C) is installed, remove the cooling liquid line and discard the o-ring. 6) remove the vacuum hose from the front of the engine, remove the plug from the appliance, and mark it. 7) remove the vacuum tube of the brake pump, remove the throttle line and remove the brace. 8) remove the power steering pump bracket and power steering pump and remove the pump with pipeline. Remove fuel piping and plug it. 10) remove the throttle cable from the shift drive bridge and the automatic transmission line. 11) remove the exhaust manifold and heat shield. 12) remove the hose from the radiator and remove the coolant recovery container and remove it. 13) install the engine support tool j-28407-a or replaceable tool to remove the engine right support. 14) lift and hold the car safely and drain off the oil pan lubricant. 15) remove the front wheel assembly and remove the fender at the lower right. 16) remove the electrical plug of the ABS wheel speed sensor and remove the grounding line on the transmission bridge. 17) remove the o