船检术语（Substituting the term）.doc

船检术语（Substituting the term） 1, hull Structural integrity and weld inspection after completion of section 56 Inspection structure integrity and welding seam on completing No. 56 block. Inspection of structural integrity after the superstructure Inspection structure integrity after completing the superstructure. The assembly accuracy and structural integrity check of large joints after closed with No9 Checking the joint accuracy and structure integrity between No. 8 and No. 9 block after closed. Inspection of structural integrity of superstructure Checking structure integrity of superstructure (deckhouse) after closed. Inspection of installation accuracy of cargo hatch coaming board Accuracy of hatch coaming on Weld inspection after welding of cargo hatch coaming You can use seam of hatch coaming after welding. The No1 ballast tank (no.15 section) pressure test (head test) check Inspection air pressure test (with water head) for No1. Ballast water tank (No15 block). Test of upper deck washing water test Inspection hosing test for upper deck. The main scale, length, length, width, depth and base deflection of the hull are measured before launching Measuring hulls main dimensions: length overall (LOA.), length between perpendiculars (LPP.), breath molded (b. MLD.), the depth molded and deflection before launching. Check the distance between draught marks and plate keel after marking Inspection distance between draught marks and keel plate after marking out. Check the accuracy of draft mark (load line mark) The fitting accuracy of draught mark (loadline mark). Check the dimensions of the load line mark Inspection dimension of loadline after marking out. Inspection of rudder leaves after completion Checking rudder after completing (finished). Cargo hatch cover weld and dimension check Inspection welding seam and dimension of cargo hatch cover. 2. Internal machinery of the turbine Inspection of machining dimensions of propeller shaft (intermediate shaft) The Inspection of