989-YC_T 18-1994（）.docVIP

989-YC_T 18-1994（） YC/T 18-1994 Production process of tobacco leaf reproducing The 1994-08-23 release The 1994-09-01 implementation of Standards of tobacco industry of the Peoples Republic of China YC/T 18-1994 Production process of tobacco leaf reproducing The state technical supervision bureau was approved by 1994-08-23 The 1994-09-01 implementation of Theme content and scope of application This standard stipulates the main process technical requirements of the leaf hanging rod and leaf compound baking process. This standard applies to the first smoke and white rib smoke. 2. Reference standard: GB2635 flue-cured tobacco GB8966 burley tobacco 3. Rebaking process rules for hanging rods 3.1 initial smoke reception 3.1.1 after the first cigarette is in the factory, the smoke should be tested according to GB2635. 3.1.2 at the beginning of the same origin, the tobacco pack shall be stacked in the same place and in the same class, and the stacking shall be in order and the passageways (in accordance with the transportation and safety fire prevention requirements) shall be kept. No more than five cigarette packets; Moderate smoke does not exceed 6 smoke packs; No more than seven smoke packs are found in the lower smoke. 3.1.3 the storage site of the first tobacco: indoor storage should be kept in a dry, ventilated, free of harmful substances and odors. The smoke pack is placed on the moisture-proof ground with the mat material, the stack is 400mm above the wall. Open air pile should take the measure that ventilates, moistureproof, prevent rain, prevent frost, the smoke pack stacking should be over 300mm above ground. 3.1.4 during the initial period of the storage of tobacco smoke, the moisture of tobacco leaf and the temperature of the smoke packet should be checked regularly, and the protection of the tobacco leaf mould and the wormhole should be kept for more than 20 days, and the measures of sealing and reducing oxygen should be adopted. At the beginning of the smoke T