螺丝电镀（Screw plating）.docVIP

螺丝电镀（Screw plating） Basically all screws have to be electroplated, mainly to resist corrosion and rust prevention. For example, zinc plating, zinc plating, zinc plating, black nickel plating, etc The non-plating is also black processing, mainly to prevent rust; Hardware screws from production, there are metal screws and stainless steel hardware screws. Iron hardware screws are required to be electroplated. Thats what we call electroplating. There are ordinary electroplating, such as color zinc, blue zinc, black zinc, white nickel, etc. There are also electroplating environmental protection. For example, there are environmental protection white zinc, environmental color zinc, environmental nickel, environmental protection and zinc. In general, stainless steel screws are not required for plating. You just have to clean it. Make the stainless steel screw surface light. The following is a simple introduction to the basic knowledge of screw plating: (Electroplating) is using the principle of electrolytic plating on the screw surface on a thin layer of other metal or alloy plating process, is the use of electrolytic action make the screws or other material adhered on the surface of the parts of a layer of metal film process to prevent corrosion, improve wear resistance and electric conductivity, reflective and improve aesthetics, and so on. The quality of screw plating is mainly measured by its corrosion resistance, followed by appearance. Corrosion resistance is an imitation of the working environment of the product, which is set to test conditions and corrosion test. The quality of electroplating products is controlled from the following aspects: 1. Appearance: Screw the surface of the product are not allowed to have local without coating, burning, rough, dark, peeling, the condition of crust and stripes obviously, there is no pinhole pitting, black plated slag, passivation membrane loose, crack, fall off and the serious passivation. 2. Coating thickness: The operating