锅炉运行司磨（Boiler running mill）.docVIP

锅炉运行司磨（Boiler running mill） The boiler runs the mill position First, the inspection project before the first start of the system? Answer: all work ends, the auxiliary machine tries to pass the qualification, the work site should be cleaned, and the lighting is sufficient to be put into operation; In the range of the powder system, there is no spontaneous combustion phenomenon, and the bulk debris, dust and other combustible materials are removed. The back powder tube and the lower powder tube are unblocked, the upper and lower lock air lock is complete, the test is flexible, each temperature, the negative pressure measuring point should be fully normal input; All doors, baffle openings, doors of doors, explosion-proof doors are complete, there is no air leakage. The coarse powder separator adjusts the baffle to the desired position of fineness; The fine powder separator is complete with wood chip separator, and there is no clutter on the sieve. The wood block splitter is complete, the inside of the sieve is not sundry, flexible and easy to use, electric push rod power supply, the movement is normal; Complete fire extinguishing equipment and closing doors and separate doors; The powder bit measuring device is complete, flexible, and the powder is drawn to the highest position. The coal bunker has enough raw coal to give the coal machine a complete good, and the coal bucket is pulled out. The monitor on the mill is well and engaged. The remote control device of the powder system is flexible, correct and the transmission device is strong and complete. The lubricating oil cup of the screw feeder is sufficient and the oil in the lubricator is added up. 2. Precautions in the operation of powder system? Answer: in order to keep the powder system in the condition of qualified coal fines, to achieve the maximum grinding power operation, the duty crew of the system must pay attention to the following items: 1. Keep the coal in the coal machine properly, so that the coal shall