全国电工进网作业许可考试试题(a1—a2卷)（Examination questions of national electrical network operation permit (A1 - A2)）.doc

全国电工进网作业许可考试试题(a1—a2卷)（Examination questions of national electrical network operation permit (A1 - A2)） National work permit test for electrical access network High voltage theory examination questions (2008, A1 volume) A single top choice (options for each question, only one of the most to do, 1 points for each question, the wrong election or not is 0, a total of 40 points) 1. electrical equipment from the accident to overhaul should be (A) A. fill in the work ticket, B. can not fill in the work ticket, direct maintenance, C. report, the leadership of the overhaul; 2. voltage fluctuations are expressed as a percentage of a voltage rating during the period of voltage variation (B) A. voltage actual value and voltage rating. B. voltage maximum and voltage minimum. C. voltage maximum and voltage rating 3. insulation gloves and insulation shoes should be tested periodically, the test cycle is generally (C) months A.1; B.3; C.6; D.12; 4., the most reasonable current density, obtained by comparison of various economic and technical aspects, is called (B) A. rated current density; B. economic current density; C. allowable ampacity; D. rated ampacity; 5. power supply quality refers to power quality and (A) A. power supply reliability; B. power supply economy; C. power supply service quality; 6. switching operation, should be first in (B) to simulate the operation. A. B. simulation of the actual equipment on board; C. operation ticket; D. blank sheet; 7. the transformer two winding short circuit (A) applied voltage to make its current reach the rated value, at this time the applied voltage is called the impedance voltage A. primary winding; B. two winding; C. high voltage winding; 8. in power systems, (A) can connect lines of different voltage levels A. transformer; B. current transformer; C. voltage transformer; The rated current range of the 9.GN2-10 series isolation switches is (A) Amperes A.400-3000; B.540-2000; C.630-1000; 10. the magnitude of the transformers temperat