化验所用仪器（Instrument used in laboratory）.docVIP

化验所用仪器（Instrument used in laboratory） Laboratory operating procedure for analytical balance 1, all new acquisition days should be measured by the verification average, issued a certificate before you can use. The balance shall be checked annually by the meter to ensure the accuracy of the balance. 2, the use of scales should be in accordance with the instructions required to operate, weighing before checking whether the balance is intact. 3, the use of the balance before the observation level in the air bubble is in the center of circular levels, such as off center, should be adjusted to keep the bubbles in the anchor bolt is the central level, single pan balance (Mechanical) anchor bolt to adjust the front of the anchor bolt behind electronic balance adjustment. 4, the balance shall be placed in such as silica gel desiccant, silica gel before use should observe the color, such as silica gel silica gel drying discoloration must be replaced in a timely manner, the failure of the water into the oven drying to restore the color of silica gel for later use. 5, the balance should be adjusted before use zero, electronic balance before use, but also the use of standard weights calibration. 6, in order to protect the balance of the knife edge, the use of a single plate balance should be half open, to be able to determine the weight of the weight of the so-called decimal point after the first digit, the weights will be accurate, and then completely open to read the exact value. 7 days, the exit switch moves to light, vibrations affect the accuracy of balance and accurate readings. 8, balance to balance the door shut, no open day exit reading, to prevent the air flow amount of the influence of symmetry. 9, the electronic balance of the peeling key should be used carefully, strictly prohibited to use the peeling key to make the balance back to zero. 10, if the balance of the tray on the dirt, immediately wipe clean. Balance should be often cleaned, keep clean, wipe the balance