富你（You are rich）.docVIP

富你（You are rich） Safety operation rules for all types of work A, furnaceman, iron industry 1, before the job, you must wear good labor protection products, strictly prohibit wearing wet gloves, wear wet overalls and shoes, wear bad, no posts, do not open your mouth when you work. 2, to achieve civilized production, the platform is good, clean and clean, no water around the furnace and other debris. 3, after the shift must be ready for anything, carefully check the tools and furnace tamping machine. If the electrical par10, operators on the principle of electric furnace transformer is not allowed to overload, but only allow 20% of the rated load, the maximum impact current of 30%, and shall not exceed 8 seconds. Three. Electrode worker 1, the job must wear good labor protection products. 2, must check whether the tool is solid and intact, hammer electrodes must be brought with protective glasses. 3, in the general, loading and unloading electrodes, we should pay attention to moving, placing and stabilizing. 4, traffic or single beam lifting stand under the non lifting electrode, lifting material, personnel around 2 meters away from the outside. 5. The electrode is connected with the crane and the electrode is clamped by the special clamp. The tightening joint must be firm and flat, the surface shall not be convex and concave, and the surface impurities shall be removed. 6, the electrode length should be carefully checked before the electrode quality, such as roundness, surface and silk first, unqualified electrodes are not allowed to use, and when the length of the old and new electrodes of the center, in a straight line, must not be distorted. 7, the operator or iron tools and other metal blocks can not contact the two phase electrode at the same time, in case of personal and equipment accidents. 8, after the electrode work is finished, the electrode platform must be cleaned. Four 、 furnace maintenance worker 1, before going to work to wear good labor protection pro