09年实物（09 years in kind）.docVIP

09年实物（09 years in kind） 2009 grade two construction division qualification test paper Professional engineering management and Practice (Construction Engineering) First, individual choice questions (20 questions, 1 points each). Each item options, only 1 of the most to do) 1. a building, two floors on the ground as a temporary storage, the room is filled with cement at a uniform height, according to the load surface classification, the two floor of the building load distribution is (A?). P2 A. load on both sides of the cloth B. line load C. concentrated load D. distributed load As shown in figure 2., using a sling lifting for W components, two cable components and the angle is alpha, hanging point symmetry, oblique force maximum angle alpha is (? A?). P 2 A.30 degrees B.45 degrees C.60 degrees D.75 degrees 3., according to the stress characteristics of reinforced concrete beams, beams and plates are typical (C) components. P 8 A. compression B. tension C. bending D. torsion 4. multi-storey small brick building parapet over the minimum height (? A? M), should be added to the top beam anchor column or column structure. P 15 A.0.50 B.0.75 C.0.90 D.1.20 5. steel structure steel is mainly hot-rolled steel plate and shaped steel, etc., the minimum thickness of steel plate is larger than (B), mm is thick plate, mainly used in the structure. P 21 A.3 B.4 C.5 D.6 6., when the construction site of the construction control network for the grid or axis form, the use of (A) building details of the plane location of the most convenient measurement. P 42 A. rectangular coordinate method B. polar coordinate method C. angle intersection method D. Distance Intersection Method In the excavation of the 7. shallow foundation pit, the earthwork and building materials shall be piled at the edge of the foundation pit, and the maximum stacking height shall not exceed (B) M. P 43 A.1.2 B.1.5 C.1.8 D.2.0 8. brick foundation construction, brick foundation corner and juncture should be masonry a