ansys使用手册（ANSYS manual）.docVIP

ansys使用手册（ANSYS manual） The eleventh chapter creates geometric display 11.1 display geometry with GUI Geometric display is the display of geometric features of a model (key points, surfaces, nodes, units, loads, etc.). This display is generated mainly during model generation and analysis during load definition. A typical geometric display is shown in figure 11-1. Figure 11-1 a typical geometric display Many users find and control the geometric display the most convenient way is to use the function of Utility, MenuPlot and Utility MenuPlotctrls under the graphics in addition, action and control command can also speak with the following paragraphs. 11.2 create the display of entity model entities The following command creates the display of the entity model entity command GUI menu path purpose APLOT MainMenuPreprocessorOperateShow DegeneracyPlot Degen Areas Utility MenuPlotAreas UtilityMenuPlotSpecified EntitiesAreas Display plan EPLOT Utility MenuPlotElements Display unit diagram KPLOT Utility MenuPlotKeypoints UtilitymenuPlotSpecifiedEntitiesKeypoints Display key points diagram LAYPLOT UtilityMenuPlotLayered Elements The stacking order of the display layer and the angular orientation of the layer cell types (such as SOLID46 and SHELL91) LPLOT Utility MenuPlotLines UtilitymenuPlotSpecifiedEntitiesLines Display line chart NPLOT Utility MenuPlotNodes Display node diagram /KEPLOT Utility MenuPlotReplot Perform the last display action VPLOT MainmenuPreprocessorOperateShow DegeneracyPlot Degen VOLUS Display degenerate volume map Controls created before triggering these actions can also produce displays that contain other information, such as lower entity numbers (such as entity numbers associated with selected units), loads, and so on. 11.3 change the geometry display instructions In addition to the features listed below, the eighth chapter applies to any type of display, including the general graphical specification of geometric display. 11.3.1 changes the style of displ