midas如何处理铰接（midas如何处理铰接）.docVIP

midas如何处理铰接（midas如何处理铰接） 1, how to establish a model of variable cross-section continuous beam (continuous rigid frame) by plate element? How to input the prestressed steel beam after the model is established? The use of plate elements to establish a continuous rigid frame (variable cross-section method) can be briefly explained as follows: 1) first, establish a parabola (variable cross section, lower flange); 2) use the unit expansion function to expand from a straight line to a plate element, and select a projection when extended to the upper flange. ; 3) establish a linear beam (extended transition) at the upper flange, then extend to the plate element at the middle, lateral and outer overhanging edges respectively; 4) use the unit mirroring function to mirror the other half horizontally; 5) for observation convenience, in the unit command, the unit coordinate axis of the plate unit is unified by using the modification unit coordinate axis option in the unit parameter modification function. In the method of prestressed steel beam plate element or entity block unit, the designers generally use method and virtual truss element, namely the truss element simulation of steel beam, and then to the truss element to a certain temperature, so as to achieve the effect of eliminating stress and. The magnitude of temperature drop should consider the tension after the loss of prestress. This method can simulate prestress loss of steel beam along the length direction, but because many software can not provide on board unit or block unit can be considered six kinds of prestressing loss of steel beam, so many designers commonly employed in this simplified analysis method. MIDAS is currently developing modules on panels and block units with six prestressing losses to meet user requirements for analysis and design. 2, if the beam and beam are folded through the wing plate, how does the Midas/Civil model simulate the splice between the beam and wing plates? The transverse virtual b