基于DSP 的单相桥式级联逆变器SPWM 的研究 - 工矿自动化.PDF

5 工 矿 自 动 化 No.5 2010 5 Industry and Mine Automation May 2010 : 1671- 251X(2010) 05- 0071- 04 DSP SPWM 韦宝泉, 胡文华, 曾建军 ( , 330013) : 级联型多电平逆变器拓扑及其控制策略 研究和实现是当前高压大功率电能变换器实现 重要 环节文章介绍了2 桥级联五电平逆变器 主电路,采用了载波相移PWM 法对其控制,分析了电路 工 作原理和控制规则, 推导出了输出电压 解析表达式; 采用TI 公司DSP 芯片TMS320F2812 控制器设计实 现了控制电路对2 桥级联型五电平逆变器 输出电压波形和频谱 实验分析结果验证了理论分析 正 确性,证明了控制方法 正确性和DSP 实现载波移相技术 便捷性 : 级联全桥型逆变器; 多电平逆变器; 拓扑结构; 控制策略; 载波相移法; DSP; SPWM : TM921. 5 :A Research of SPWM of Single Phase Cascade Fullbridge Inverter Based on DSP WEI Baoquan, U Wenhua, ZENG Jianjun (School of Electrical and Electronic Engineering of East China Jiaotong University, Nanchang 330013, China) Abstract: Research and realization of topology and control strategy of cascaded multilevel inverter are important parts of high voltagepower converter with large power. In the paper, main circuit of 2 bridge cascaded fivelevel inverter was introduced in which carrier phase shift SPWM technology was adopted. The working principle and control rules of the circuit were analyzed and then the analytical expression of output voltage was deduced. T MS320F2812 controller of TI was used for control circuit. The results of experiment of output voltage wave and frequency spectrum of 2 bridge cascadedfivelevel inverter verify the theoretical analysis and experimental results are consistent, which proves correctness of the control method and convenience of the DSP used for realizing the phase shift SPWM technology. Key words: cascadedfullbridgeinverter, multilevel inverter, topological structure, control strategy, carrier shift method, DSP, SPWM ;(2) , 0 ; (3) ,