A Honeywell Company Gas Burner Safety Control（霍尼韦尔公司天然气燃烧器安全控制）.pdf

DMG 972 A Honeywell Company Gas Burner Safety Control For 2-stage forced draught and combi oil/gas burners, facility to connect an air damper unit Possible flame detectors: - Ionisation probe - Infrared flicker detector 1020 - UV flame sensor UVD 971 INTRODUCTION The burner control box DMG 972 controls and supervises power burner for gas and dual fuel. The control box is approved and certified according the relevant European standards. The use on direct air heaters according DIN 4794 is also possible. With the facility to connect an air damper unit, a 2 stage operation with two fuel valves or a modulating operation TECHNICAL DATA with one fuel valve is possible. Operating voltage 220 / 240 V (-15... +10%) The microprocessor- based programming sequence ensu- 50 Hz ( ±5%) res extremely stable timings independent of voltage varia- or 110 / 120 V (-15... +10%) tions, ambient temperature and/or switch-on cycles. The 60 Hz ( ±5%) built-in information system not only provides a continuous Fuse rating 10 A fast, 6 A slow monitoring of the actual state of the box (very helpful es- Power consumption ca. 12 VA pecially for monitoring the start-up phase) but also informs Max. load per output