有杆抽油系统工况分析（Analysis of working conditions of sucker rod pumping system）.docVIP

有杆抽油系统工况分析（Analysis of working conditions of sucker rod pumping system） Analysis of working conditions of sucker rod pumping system The purpose of the analysis is to understand the oil production of oil production capacity, equipment capacity and their working conditions, provide the basis for further formulating reasonable technical measures, the equipment capacity and the ability to adapt to the reservoir, give full play to reservoir potential, and make the equipment to work normally under the condition of high efficiency, to ensure the high yield and high efficiency of pump oil production. To this end, pumping well analysis should include the following: (1) understanding the production capacity and working condition of reservoir, analyzing whether the reservoir potential has been brought into play, and analyzing and judging the reason why the oil reservoir is not working properly. (2) to understand the equipment capacity and working conditions, to analyze whether the equipment is suitable for oil production capacity, to understand the equipment potential, to analyze and determine the reasons for the abnormal equipment. (3) analysis and check the effect of measures. In a word, the analysis of the working condition of sucker rod pumping system is to analyze the working condition of the oil reservoir and the working condition of the equipment and the mutual coordination between them. Test and analysis of liquid level in pumping well (1) static surface, dynamic surface and oil production index; The liquid liquid level is shut in the annular space back to rest (phase equilibrium and formation pressure) when the liquid level can be expressed its position with a depth of Ls from the wellhead date, can also be used from the middle level reservoir is Hs to indicate its position. The bottom hole pressure corresponding to it is the reservoir pressure. The liquid level is the liquid level in the annular space of the oil sleeve when the oil well is produced. You can use the d