延性RC剪力墙构件性能指标限值_劳晓春.pdfVIP

第 28 卷第 9 期 Vol.28 No.9 工 程 力 学 2011 年 9 月 Sep. 2011 ENGINEERING MECHANICS 157 文章编号：1000-4750(2011)09-0157-08 延性RC 剪力墙构件的性能指标限值 *劳晓春 1,2，韩小雷 1,2 (1. 华南理工大学土木与交通学院，广州 510640 ；2. 华南理工大学亚热带建筑科学国家重点试验室，广州 510640) 摘 要：为了得到基于中国规范设计的延性 RC 剪力墙构件的变形性能指标限值，先通过文献中 7 片剪力墙构件 的试验数据验证有限元方法的可靠性，然后采用有限元方法对根据现行中国规范设计的一批剪跨比λ≥2.0 的延性 RC 剪力墙构件进行模拟分析，研究剪跨比、边缘构件的纵向配筋率、轴压比等因素对剪力墙构件变形性能的影 响，最后通过对有限元结果的归纳分析，提出基于中国规范的延性 RC 剪力墙构件的变形性能指标及其限值：选 取塑性区的塑性转角作为 λ≥2.5 的RC 剪力墙构件的性能指标并给出其在大震下的塑性转角限值，选取塑性位移 角作为 2.0≤λ2.5 的RC 剪力墙构件的性能指标并给出其在大震下的塑性位移角限值。 关键词：RC 剪力墙；性能指标限值；有限元方法；中国规范；剪跨比 中图分类号：TU973 + .12 文献标志码：A THE PERFORMANCE INDEX LIMITS FOR DUCTILE RC SHEAR WALL COMPONENTS *LAO Xiao-chun1,2 , HAN Xiao-lei1,2 (1. School of Civil Engineering and Transportation, South China University of Technology, Guangzhou 510640, China; 2. State Key Laboratory of Subtropical Architecture Science, South China University of Technology, Guangzhou 510640, China) Abstract: In order to determine the deformation performance index limits for ductile RC shear wall components based on Chinese codes, the test data of seven shear wall components in other published articles are first used to verify the reliability of the finite element method. Then, the finite element method is applied to analyze a set of ductile RC shear wall components with shear span ratio λ≥2.0 and designed according to current Chinese codes. And the impact of the following factors on the deformation performance of RC shear wall components is studied: shear span ratio, longitudinal reinforcement ratio of the confined boundary members and axial compression ratio. Finally, the deformation performance index and the