数控应用（NC Application）.doc

数控应用（NC Application） Gear modeling parameter D=z*m Df= (z-2*h-2*c) *m Da= (z+2*h) *m Db=d*cos (angle) involute equation R=db/2 Angle=t*45 X=r*cos (angle) +pi*r*angle*sin (angle) /180 Y=r*sin (angle) -pi*r*angle*cos (angle) /180 Z=0 Cylindrical coordinate R=db/2/cos (t*55) Theta= (Tan (t*55) *180) /pi-t*55 Z=0 Material outer circle 35 length 30, numerical control processing thread, M30x1.5 length 20, please expert advice programming, concrete how to process, please expert advice, Sese Sel outer circle knife car to how many outside circle? Reprocessed thread??? Chuck holding material more than 10mm, the outer circle to the size of the end surface length of more than 10mm. The length of the clip holder is 9mm. End to end length. Outer circle to 29.9MM length 20MM, car return slot (if required). Thread G92 to dimension. The bottom of the tooth is 28.05MM What should pay attention to when NC machining thread? Know the programming format on the line, and different system formats are not the same, CNC machining thread programming simple, difficult to process, especially tool preparation, G92 G32 When you screw thread, how do you prevent the phenomenon of collapsing when turning? This problem is quite simple, the tool is pressed on the center line of the workpiece, that is, the cutter face is in the middle of the lathe. There is a deviation of 0.5 millimeters from top to bottom. The thinner the thread, the smaller the deviation. When sharpening, the back angle can not be worn too big, the back angle is too big, is so-called grinding falsely. The auxiliary rear angle can not be grinded too much. The pitch is large, the back angle is large, and the back angle is slightly larger than the helix angle. Press the knife rod cannot elongate, slender thread cutter can not shake, car for higher requirements in all aspects. The car with the model angle to the surface of the knife as long as the car can meet the angle. As long as the first half of the tool meets the sample line, it can