高层框剪结构住宅楼板开裂处理方法（Floor cracking treatment method of high-rise frame shear structure residential building）.doc

高层框剪结构住宅楼板开裂处理方法（Floor cracking treatment method of high-rise frame shear structure residential building） Floor cracking treatment method of high-rise frame shear structure residential building A high-rise residential building in Shenzhen consists of two towers, the frame shear wall structure, the basement 1 floors, the ground 2 floors, the standard floor area of 117 square meters, with a total construction area of 41000 square meters. The 1 tower construction on the tenth floor in 8D and demolished concrete beam Banmo, found the floor local cracking phenomenon, especially in the north of the two suites, two pieces of 7.2m * 8.0m slab crack distribution and water conservation when the leakage is obvious. After analysis, the reasons for the cracks are as follows. Because of the concrete pouring, the surface is not timely covered by hot weather effect and exposed to the weather, surface free water evaporates quickly, causing shrinkage speed, the plate shrinkage value is much greater than the beam shrinkage, additional thermal shrinkage difference, thereby increasing the plate surface tensile stress, and the concrete early low strength (especially with fly ash concrete, low early strength, high water absorption rate), can not resist the deformation stress and cracking. 1 several treatment methods of floor cracking Because shrinkage cracks are early development type, it is unlikely to continue under the influence of the environment. More than 1 months later, the cracks on the surface of the cracks were no longer developed, and the cracks tended to be stable. There are four kinds of cracks in this project: (1) the crack width is less than 0.3mm, no harmful effect on the structure bearing capacity and endurance strength, can not process; (2) the non penetrating cracks of width 0.3mm can cause corrosion of reinforcing bars and influence the lasting bearing capacity of structures; (3) the cracks which are not scattered and scattered will cause corrosion of reinforcing bars