屋面保温层施工工艺(1001-1996)（Construction technology of roof insulation layer (1001-1996)）.docVIP

屋面保温层施工工艺(1001-1996)（Construction technology of roof insulation layer (1001-1996)） You can enjoy a grander sight by climbing to a greater height。 Pride hurts, modesty benefits. Sharp tools make good work。 Snow outside the door, Qianshan green, flowers hair riverside, February fine. Bamboo outside peach 32 branches, spring plumbing duck prophet. This process standard applies to the construction of industrial and civil engineering roofing with loose and plate shaped thermal insulation material and cast-in-place whole heat preservation material insulation layer project. 2.1 materials and requirements: 2.1.1 material density, thermal conductivity and other technical performance must comply with the design requirements and construction and acceptance specifications, there should be test data. Loose insulation materials should be used inorganic materials, such as the use of organic materials, should first do a good job of anti-corrosion treatment of materials. 2.1.2 material: 2.1.2.1 material: loose slag or slag, the particle size is 5 ~ 40mm, shall not contain stones and clods, heavy slag and unburned coal, the bulk density is 500 ~ 800kg/m3, the coefficient of thermal conductivity is 0.16 ~ 0.25W/m / K. Thermal conductivity of expanded vermiculite 0.14W/m = K. 2.1.2.2 board insulation material: the product should have the factory certificate, according to the design requirements, thickness, specifications should be consistent, the shape should be neat, density, thermal conductivity, strength should comply with the design requirements. A. foam concrete plate: performance density is not greater than 500kg/m3, compressive strength shall not be less than 0.4MPa; B. aerated concrete plate: apparent density of 500 ~ 600kg/m3, compressive strength shall be no less than 0.2MPa; C.: the performance of polystyrene board density is less than 45kg/m3, the compressive strength of not less than 0.18MPa, the coefficient of thermal conductivity is 0.043 W/m K. 2.2 main machines and too