手机充电器及电池原理(Mobile phone charger and battery principle).docVIP

  • 16
  • 0
  • 约7.01千字
  • 约 5页
  • 2017-08-03 发布于河南
  • 举报

手机充电器及电池原理(Mobile phone charger and battery principle).doc

手机充电器及电池原理(Mobile phone charger and battery principle) In this paper, the working principle of a switch type mobile phone charger is introduced in detail. It is very meaningful for beginners to understand the specific switching power circuit and charging control circuit. Chaolitong travel charger for mobile phone Motorola 308, 328, 338 and 368 series of mobile phone battery. The charger has Ni Cd, Ni MH, Li ion battery charging switch, and has discharge function. When 150 to 250V and 40mA AC power input, the output current of 300 + 50mA can be output. Draw the working principle drawing according to the material, for the readers reference. The charger uses the RCC switching power supply, that is, the oscillation suppression converter, which is different from the PWM switching power supply. PWM switching power supply by sampling error amplifier and DC amplifier composed of independent pulse width modulation system; RCC type switching power supply regulator composed only by the level switch control process for oscillation and suppression. Because the switch PWM type power switch is always periodic on-off control system, just change the pulse width of each cycle, but not linear control process of RCC type switch power supply of continuous change, it has two states: when the output voltage exceeds the rated value, the controller outputs low level pulse tube cut-off switch; when the output switching power supply voltage is lower than the rated value, the controller outputs high level pulse on-off tube. When the load current is reduced, the discharge time of the filter capacitor is prolonged, and the output voltage is not reduced very quickly. The switch tube is in the cut-off state until the output voltage is lowered to the rated value, and the switch tube is re connected. The cut-off time of the switch depends on the magnitude of the load current. The turn-on / stop of the switch is controlled by the level switch sampled from the output voltage. Therefore, the power supp

您可能关注的文档

文档评论(0)

1亿VIP精品文档

相关文档