滤波电容的选择（Selection of filter capacitor）.docVIP

滤波电容的选择（Selection of filter capacitor） After the rectifier bridge is pulsating DC, a large range of fluctuations. Two capacitors are usually used in the rear Large capacitors are used to stabilize the output, and it is well known that the voltage at both ends of the capacitor can not be mutated, so that the output can be smoothed The small capacitor is used to filter the high frequency interference, so that the output voltage is pure The smaller the capacitance, the higher the resonance frequency, the higher the interference frequency can be filtered out Capacity selection: (1) the larger the capacitance, the heavier the load, and the stronger the ability to absorb the current, the greater the capacity of the capacitor (2) small capacity, with experience, general 104 can 2. other peoples experience (from the Internet) 1, the capacitor to ground filter requires a smaller capacitor parallel to the ground, providing a high frequency signal to the ground path. 2, the power filter, the capacitor to the foot as close as possible. 3, in theory, the power filter capacitor as much as possible, generally large capacitance filter low-frequency wave, small capacitor filter high-frequency wave. 4, a reliable approach is to a large, small, two capacitors in parallel, generally require a difference of more than two orders of magnitude, in order to obtain a greater frequency band Specific case: AC220-9V after the full bridge rectifier, the filter capacitor is required to increase how much? What is the capacitance required to go through 78LM05 again? The former capacitor withstand voltage should be greater than 15V, capacitance capacity should be greater than 2000 micro hair above. The latter capacitor voltage resistance should be greater than 9V, capacity should be greater than 220 micro hair above. 2. there is a capacitor filter single-phase bridge rectifier circuit, the output voltage is 24V, the current is 500mA: (1) select the rectifier diode; (2) choosing filter capacitor; (3)