线路板材质（PCB material）.docVIP

线路板材质（PCB material） According to the grade level, from bottom to height is divided as follows: 94HB/94VO/22F/CEM-1/CEM-3/FR-4 Details are as follows: 94HB: ordinary board, not fireproof (most low grade material, die punching, cant make power board) 94V0: flame retardant cardboard (die punching) 22F: single sided semi glass fiber board (die punching) CEM-1: single-sided fiberglass board (must be drilled, not punched) CEM-3: double sided semi glass fiber board (except double sided cardboard) is the most low-end material of double sided board. Simple double sided board can be used with this material, 5~10 yuan / square meter will be cheaper than FR-4 FR-4: double sided glass fiber board Best answer A.C flame retardant grade classification can be divided into 94V - 0, /V-1, /V-2, 94-HB four Two. Prepreg: 1080=0.0712mm, 2116=0.1143mm, 7628=0.1778mm Three,.FR4, CEM-3 are plates, FR4 is glass fiber board, cem3 is composite substrate Four. Halogen free refers to the base material that does not contain halogen (fluorine, bromine, iodine, etc.), because bromine will produce poisonous gas when burning, and environmental protection requirements. Six.Tg is the glass transition temperature, that is, the melting point. The circuit board must be flammable and not burn at a certain temperature and can only be softened. The temperature point at this time is called the glass transition temperature (Tg point), which is related to the dimensional stability of the PCB plate. What are the advantages of high Tg PCB boards and the use of high Tg PCB? High Tg printed board, when the temperature rises to a certain area, the substrate will change from glassy to rubbery state, and the temperature at this time is called the glass transition temperature (Tg) of the board. That is to say, Tg is the highest temperature of the substrate to maintain rigidity (DEG C). That is to say the common PCB substrate material under high temperature, not only produce softening, deformation, melting and other phe