PLC指令（PLC instruction）.docVIP

PLC指令（PLC instruction） In order to respond to the current value of a counter S2, this instruction will produce an output mode (with n already addressed output) types. ADD merges the source data (S1, S2) and saves the merge result to the specified target soft component D. Using ALT, ALT takes turns in the state of the targets soft component (D). Every change in a soft component will be scrolling between ON and OFF. The AND instruction is used for the series connection of the contact, which can connect the required contacts in serial. AND the comparison of the instructions, test the values of S1 AND S2. If the result of the comparison is TRUE, the contact AND valid. If the comparison is FALSE, the contact AND invalid. AND = test the values of S1 AND S2 according to the comparison of instructions. If the result of the comparison is TRUE, the contact AND valid. If the comparison is FALSE, the contact AND invalid. AND , based on the comparison of instructions, test the values of S1 AND S2. If the result of the comparison is TRUE, the contact AND valid. If the comparison is FALSE, the contact AND invalid. AND = based on the comparison of instructions, the values of S1 AND S2 are tested. If the result of the comparison is TRUE, the contact AND valid. If the comparison is FALSE, the contact AND invalid. AND tests the values of S1 AND S2 according to the instructions. If the result of the comparison is TRUE, the contact AND valid. If the comparison is FALSE, the contact AND invalid. AND = test the values of S1 AND S2 according to the instructions. If the result of the comparison is TRUE, the contact AND valid. If the comparison is FALSE, the contact AND invalid. The ANDFANDF instruction is used for the series connection of pulse contacts The ANDP instruction is used for the series connection of pulse contacts The ANI command is used to connect a series of contacts that connect the dots in a serial connection. ANR each time an ANR command activated the alarm to be reset