道路照明控制（Road lighting control）.doc

道路照明控制（Road lighting control） Remote control of road public lighting New technologies in electronics and communications are surprisingly enabling remote control of public lighting. Use of remote control, even with existing lamps and lanterns, can achieve the purpose of improving public service level, rationalizing maintenance, energy saving, low cost and environmental protection. By remote control, we can use the computer in the region of the city or any a light switch control, individual dimmer, instantaneous learn failure message and all the light of the existing automatic database upgrade. Main structure and operation principle The system (figure. 1) has a local controller for monitoring in each area except the computer, and each light source point has a lamp controller. The main structure of the remote control system depends on the device and its location (FIG. 2) that need to be controlled. Therefore, the system must be able to distinguish between the different regions and devices involved. A communication network based on physical networks will be used for information transmission. So the main structure of the remote control system includes: ? Lamps and lanterns controller, installed on or inside the lamp light pole bottom (a set of lamps and lanterns of controller can be replaced by a single group controller, and it also cant get a single information of the lamps and lanterns) ? The regional controller (each geographic area) is installed in the control box ? Communication protocols to enable communication between different units ( mutual dialogue ) ? Software, which is used for automatic control of lighting, is also based on information input of different systems (traffic flow conditions, weather conditions, time, etc.). Provide control information at the same time (the program can be controlled manually at any time, for example, control during an accident or festival) ? Computers, perform various configurations, collect control information, and control opera